4.3 Hydrate Calculations in Aspen HYSYS | Velociss

Autoplay
Autocomplete

Previous Lesson Complete and Continue

PD2 Aspen HYSYS

1. Getting Started with Aspen Hysys

1.1 Introduction to the Simulation Basis Manager (6:56)
1.2 Defining the Simulation Basis (6:53)
1.3 Property Package Selection (3:47)
1.4. Building up simulation (6:11)
1.5 Unit Selection and input data specification (6:26)
1.6 Adding Utility (3:00)
1.7 Analyzing the results and customizing the workbook (3:35)
1.8 Finishing the simulation and printing the case (2:29)

2. Propane Refrigeration

2.1 Process Overview (9:37)
2.2 Building the Simulation (11:29)
2.3 Adding Unit operation information (3:36)
2.4 Analyzing the results (4:52)

3. Two-stage compression

3.1 Process Overview (2:13)
3.2 Building the Simulation (14:34)
3.3 Installing recycle (6:57)
3.4 Unit functions (6:18)
3.5 Analyzing the results (3:38)

4. Water content and Gas Hydrates

4.1 Introduction to the process (6:44)
4.2 Accounting for Water Content using Aspen HYSYS (12:36)
4.3 Hydrate Calculations in Aspen HYSYS (9:08)
4.4 Water Dew Point Calculation (5:36)
4.5 Hydrate Inhibition (5:33)

5. Natural Gas Dehydration with TEG

5.1 Process and Column Overview (4:46)
5.2 Building the Simulation - PART I (25:32)
5.3 Building the Simulation - PART II (8:27)
5.4 Hydrate Formation Utility (3:18)
5.5 Analyzing the results (5:59)

6. Gas Gathering

6.1 Process Overview (5:13)
6.2 Building the Simulation (21:39)
6.3 Analyzing the results (3:44)
6.4 Pressure drop consideration in pipe segment (3:45)

7. Compressor and pump curves

7.1 Introduction (4:40)
7.2 Compressor Curves (7:50)
7.3 Pump Curves (10:41)

8. NGL Fractionation

8.1 Process Overview (5:35)
8.2 Building the Simulation - PART I (11:07)
8.3 Building the Simulation - PART II (11:22)
8.4 Analyzing the results (4:39)

4.3 Hydrate Calculations in Aspen HYSYS

Complete and Continue

Discussion

0 comments